Insurance Car Auctions Calgary

Replacing sliding doors Zebra

Bearing or bearing part of the middle doors slide (slide) on the car is very easy to replace the following Zebra langkah2nya:

1. Buy bearing no. 38 for the middle of the door slides in Depok Ramanda Parts Center (special Daihatsu spare part) for Rp. 30.000, - / 2 fruit.
2. Remove the slide door closers (there skrupnya), door handle (there murnya), glass player and opening the door (there penguncinya - straight lever with a screwdriver).
3. somewhat backward prop bottom of the door using the jack and make for the door at the hinge of temporary tertopang not the center that will be released.
4. In the lower corner of the back door there was a hole there 2bh screws, washers and nuts are strong memeggang hinge bearing hook ends interlocked with the central body, loosen the lock screw and No. 13 for 14 for the nut. Be careful not to fall into the basic nuts door.
5. Once loose pull the nut using a hand so as not to fall.
6. Two bolts and nuts were off the hinges and can be taken from the rear door slides.
7. After the hinges off, the link bearings can carry out the rail through the back end contained a plastic cover that must be removed. Behind
8. cover retaining bearings are held by two screw No. 10 when the tight loosen because of rust and then spray a 4WD and occasionally in the trial of word play dikecangkan or loosened.
9. Once loose, the hinges can be released from the rails.
10. Clean and soak the link bearing occasional use "tar remover", there is a flat-headed screw and a star-eyed, have a star-edged screwdriver (there is one sets are usually sold in the market).
11. Loosen the screw when the loud, word of occasionally while trying to play. The clamp screw with a kind of pipe bearing spacer screw is hard because of the possibility of rust (of word again).
12. Once loose, the bearing can be replaced with new ones.
13. Replace bearing spacer and skrupkan pipe to link the hinge as before, return to the rail link and attach the hinges to the door and watch to try to link the position of the hinges for the doors can close the meeting. Rapihkan cover and ash doors. Then give the grease (fat) on the rail for bearing not quickly wear out. - Good luck